Concrete Slabs in Brooklyn Park, MN

Concrete Slab Contractor in Brooklyn Park, MN

Shed and Outbuilding Pads

A shed that sits on bare ground or a few blocks will shift over time, and the doors will stop closing right. A concrete pad gives it a level, permanent base that keeps moisture and pests from getting underneath. We pour pads for storage sheds, workshops, playhouses, and other small outbuildings. The pad is sized to your structure, usually with a little extra around the edges, and set level on a firm base. If you are buying a shed, check the manufacturer’s recommended pad size before we form, and pass the dimensions along to us.

Hot Tub Pads

A filled hot tub weighs thousands of pounds, so the pad underneath has to be solid, flat, and built for that load. We pour hot tub pads sized to your model, often with added thickness and reinforcement to carry the weight evenly. Because the tub has to sit perfectly level, we take extra care with the base and the finish. If you plan to run power to the tub, tell us in advance so we can leave room for conduit, and plan to have a licensed electrician handle the wiring. Send us the weight and dimensions from the manufacturer and we will build the pad around them.

Equipment Pads for AC Units and Generators

Outdoor equipment lasts longer when it sits on a flat, stable surface instead of settling soil. We pour pads for air conditioners, heat pumps, standby generators, water softeners, and similar equipment. The pad keeps the unit level, lifts it off wet ground, and gives you a clean surface to work around when it needs service. Size depends on the unit and the clearances the manufacturer calls for, so share the model number or the spec sheet when you ask for an estimate.

Grill, Fire Pit, and Outdoor Kitchen Pads

Grills, fire pits, and outdoor kitchen islands are heavy and hot, and they belong on a surface that will not crack or tilt. We pour reinforced pads sized for built-in grills, islands, smokers, and fire pit areas. If the pad is meant to sit inside a larger patio, we can plan it with the patio so the slab, the slope, and the finish all line up. Tell us what is going on the pad and how much clearance you want around it, and we will plan the size from there.

Sport and Play Pads

A flat concrete surface is hard to beat for basketball, pickleball, and other backyard games. We pour sport pads sized to the game, with a smooth, even finish and a slight slope to shed water. Drainage matters here because standing water on a game surface gets slippery and wears the concrete faster. Ask us about line painting and hoop placement before the pour, since planning the hardware ahead is easier than drilling into a finished slab.

Thickness and Reinforcement

How thick a pad should be depends on what is going on top of it. A small shed pad or an equipment pad is commonly poured at about four inches, while a hot tub or a heavy outbuilding may call for more thickness and added steel. Reinforcement helps the slab carry the load and control cracking. Control joints are planned at set spacing, so any cracking follows straight lines instead of wandering. We recommend a thickness based on your actual use, and we put it in the estimate.

Base Prep and Drainage

A slab is only as good as the ground under it. We remove soft soil, grade the area, and compact a firm base before setting forms. Drainage matters even for a small pad, because water that collects at the edges can wash out the base over time. We set a slight slope so rain and snowmelt run off the surface, and we look at where nearby downspouts and landscaping send water. If we notice a drainage problem on your site, we will point it out and talk through the fix before we pour.

Finishes for Concrete Pads

Most outdoor pads get a light broom texture, which gives shoes and equipment good grip when the surface is wet. A smoother finish suits sport pads and spots where you want an easy surface to sweep. Sealing is an option on any pad and helps protect against moisture and salt. We can talk through finish options when we walk your site.

What Affects the Cost of a Slab or Pad

Several things set the price. Size comes first, since concrete is priced by the square foot. Thickness and reinforcement add material and labor, and so does removal of an old slab or stubborn sod and roots. Base work varies with how much the ground needs, and tight access can add time. Finish and any extras, like conduit sleeves or a custom shape, play a part too. We measure the job on site and put the price in writing.

Request an Estimate for Your Slab or Pad

Whether you need a base for a shed, a pad for a hot tub, or a slab for a piece of equipment, the first step is a visit. We will look at the space, talk through the size and use, and give you a written estimate before work begins. Call us or fill out the form on this page to schedule a time.